ADIA Module
• Serial diagnosis via “slow codes” for reading/ erasing of diagnostic trouble codes
• Serial diagnosis via “fast codes”  for error reading/erasing, live data, activation tests and settings, warning lamp resetting, scheduled maintenance
• Settings, warning lamp resetting, scheduled maintenance, EOBD scan tool
• Communication protocols according to standards ISO14230 (KWP2000), ISO9411-2 (KL), SAEJ1850 PWM and VPW, CAN ISO 119898 (CAN), ISO15675-4 (CAN), ISO15031-5 (CAN)

ACQ2 Module
OSCILLOSCOPE
  • Manual settings for high/low voltage scope
  • Automatic setting, triggering and signal test via SIV functions (Signal Information Viewer)
MULTIMETER 
  • Voltmeter 0÷200 V DC
  • Ammeter 0÷2 A reading via shunt
  • Ohm meter, measurements of resistances and continuity test
PRESSURE TRANSDUCER
  • Pressure range -1÷9 bar
AMP CLAMPS
  • 10mV/A 0-100A or 1mV/A 0-400A for cars/bikes
  • 10mV/A 0-200A or 1mV/A 0-1200A for trucks
DISPERSION CLAMP
  • 1000mV/A 0-3A or 100mV/A 0-30 A for dispersion test

BPP2 Module
BATTERY TEST
  • Battery  charge and efficiency status
START TEST
  • Cranking test, earth potential test, starter motor test
RECHARGE TEST
  • Recharge current efficiency, recharge cable
  • Ripple test +D, ripple test + alt

TNET Module
CAN BUS DIAGNOSIS
  • Communication speed for high and low speed can, single wire CAN
ELECTRICAL DIAGNOSIS
  • Short and open circuits check
  • Equivalent impedance measurement at the bus nodes
  • Bus identification via transmission speed and identifier fields